Installation - Toshiba AW-B1100GM User Manual

Install your washing machine in a level, stable place.
•
It is dangerous to place the washing machine in an
unstable location since it may move during vibration.
•
It will increase the sound produced by the machine when
it vibrates during use.
When you move washing machine,
hold the handles on the sides.
There are moving parts, electrical
parts and steel plates which may
cause electrical shock or injury.
•
Never touch on the cabinet bottom by hands.
Never lift at the cabinet bottom by hands.
When the machine is covered.
Do not use the cover made of chloric vinyl. Sometimes it
damages plastic parts and painted surface. When you use
the cover made of chloric vinyl, put the cloth between the
machine and the cover.
Adjust the leg so that body of your washing machine keep flat. (The one leg is adjustable.)
1. After loosening the leg nut, adjust the leg to
the proper height by turning it. Then tighten
the leg nuts securely once again.
Loosen
Raise
2. When the leg height is difficult to adjust because
of floor slope or unevenness, place a board of
sufficient thickness to prevent breakage under
the affected legs to allow adjustment to a level position.
1 Push the cover into the washing machine from the
backside.
14

INSTALLATION

Choosing an installation location
Leveling the washing machine
Leg nut
Tighten
Leg
Lower
Installing the bottom cover
Back side
Avoid place where the machine is
exposed to direct sunlight.
•
Plastic parts may become
deformed or discolored.
Avoid places where the machine may become frozen
during cold weather.
Allow a space of at least 5 cm from the sides and rear
of the machine to the nearest vertical object.
•
When placed too near to walls
or other objects, the vibration
of the machine during operation
may cause them to shake.
3. A weight attached to a string may be used to
check to ensure that your washing machine is flat.
The difference of the distance between A and B
should be less then 1 cm.
A-B or B-A 1 cm.
String
Check the distance.
2 Tighten screws at 2 positions.
Back side
Screw Screw
Allow 5 cm