Digital Control Panel - Power Cooker PC-WAL1 Owner's Manual

general operating Instructions
For best results, always check that the Pressure Valve (fig.4, page 6), Float Valve (fig.4, page 10), Rapid
Release Button (fig.4, page 6), and Rubber Gasket (fig.1, page 6) are in good working order and that
there are no foreign particles blocking the Valve openings on the underside of the Lid. See CARE &
CLEANING INSTRUCTIONS.
• Never load Inner Pot above the MAX line. Rotate the Inner Pot to make certain that it is seated
properly on the Heating Plate.
• Always be certain the Pressure Valve is free floating and clear of any obstructions.
• Attach the AC Cord to the base of the unit then plug the AC Cord into a dedicated 120V wall outlet.
• Steam and pressure must be released completely from the Cooker before the Lid will open. To do
this, carefully slide the Rapid Release Button forward (Illustration #4 opposite page) until all pressure
has escaped. CAUtION: During this process protect your skin from any contact with escaping
• Press down gently on Lid and turn clockwise until Lid meets resistance... lift carefully and place
aside. Avoid personal injury resulting from hot unit surfaces and dripping liquids.
Note: The "cook times" shown in the recipe booklet do not include the additional time needed to
pressurize the unit before cooking begins. Full pressurization could take up to 17 minutes.
The Power Cooker has a back-up feature to prevent malfunction in the event of a power surge. In the
event of a system shut down caused by a power surge, unplug the cooker allow it to "clear" for 1 hour
before plugging it back into the outlet.
the power Cooker has up to eight basic cooking modes that may be used alone
or in combination to produce an infinite variety of results.
the Quick Start Guide supplied with this unit provides Step-By-Step instructions.
WHEN tHE UNIt IS FIRSt pLUGGED IN, 0000 will
appear on the LED Display. When a cooking process
is selected, such as COOK, the default time will blink 5
times. Then rotating double zeros may appear on the
left side of the screen to signify it is building pressure.
Once pressure is built, the zeros will stop rotating and
begin counting down the time. It will beep, the LED
Display will be blank, and enter KEEP WARM mode
once the time has expired until cancelled.
(continued)
BEFORE tHE FIRSt USE
FOR GENERAL USE
steam.
pOWER SURGE pROtECtION FEAtURE
DIGItAL CONtROL pANEL (OVERVIEW)
0000
7