Tape To Tape Recording; Recording From Radio - Hyundai H-2203 Instruction Manual

Portable stereo radio double cassette recorder
Table of Contents

Advertisement

· When the tape plays to the end on deck
· When the tape plays to the end on deck
RECORDING (DECK
TAPE MIXING - USING DECK A AND DECK B
· You may like to mix the sound recorded on two cassette tapes together.
· Set function switch to tape position.
· Insert your prerecorded cassette tape in deck A and deck B as described in previous chapter.
· Start playback of both decks by pressing PLAY buttons 8 and 17 and simultaneously. You will obtain the wondrous audio effect.

TAPE TO TAPE RECORDING

· Set the Function switch to TAPE position thus the Power LED indicator should light up.
· Insert a pre-recorded cassette into deck
· Press the RECORD button and PAUSE button on deck
· Press the PLAY button on deck
· Release the PAUSE button on deck
NOTE:
· Press the PAUSE button on deck
· Press the STOP/EJECT button on deck
· Set the Dubbing Mode switch to HI position if you wish to activate high-speed copying function. This will reduce the recording time to
about half.
NOTE:
· Do not reset DUBBING SPEED selector during dubbing.
· When the length of tape A is shorter than tape B, PLAY button of deck A is released automatically. But as RECORD button and PLAY
button of deck B are still being kept pressed, you have to press STOP / EJECT button to terminate the dubbing operation.
· When the length of tape B is shorter than tape A, RECORD button and PLAY button of deck B are release automatically at the end of tape
B. But tape A will continue to playback until it reaches its end.

RECORDING FROM RADIO

· Set the Function switch to RADIO position thus the Power LED indicator should light up.
· Tune to the desired station by turning the Tuning control regulator.
· Insert a blank cassette into deck
· To start recording press the PLAY button and RECORD button on deck
· Press the STOP/EJECT button when finished.
, deck
will be playing automatically.
, playing will be stopped automatically.
ONLY)
and a blank cassette into deck
simultaneously.
.
to start recording. Then both cassettes will start and dubbing at normal speed.
to pause the tape recording.
when the recording is finished.
.
.
simultaneously.
6

Advertisement

Table of Contents
loading

Table of Contents