DeLonghi DEF608GW Use And Care Instructions Manual page 10

ANTI-TILT BRACKET
Important!
To restrain the appliance and prevent
it tipping accidentally, fit a bracket to
its rear to fix it securely to the wall.
Make sure you also fit the supplied
lock pin to the anti-tilt bracket.
To fit the anti-tilt bracket:
1. After you have located where the
cooker is to be positioned, mark on
the wall the place where the two
screws of the anti-tilt bracket have
to be fitted. Please follow the indi-
cations given in fig. 5a.
2. Drill two 8 mm diameter holes in
the wall and insert the plastic plugs
supplied.

Important!

Before drilling the holes, check that you will not
damage any pipes or electrical wires.
3. Loosely attach the anti-tilt bracket with the two
screws supplied.
4. Move the cooker to the wall and adjust the height of
the anti-tilt bracket so that it can engage in the slot
on the cooker's back, as shown in fig. 5a.
5. Tighten the screws attaching the anti-tilt bracket.
6. Push the cooker against the wall so that the antitilt
bracket is fully inserted in the slot on the cooker's
back.
7. Access the bracket and fit the lock pin:
■ Remove the drawer (fig. 5b).
■ Fit the lock pin through the bracket, as shown (fig.
5c).
■ Refit the drawer.
1
Lock pin
Slot on the
cooker's back
10
Figure 5a
0
+15
Figure 5c
Anti-tilt bracket
attached on the
rear wall
Cooker's
Lock pin
back
correctly
fitted
Dotted line showing the position of
the cooker when installed
min 95 - max 110
(depending on feet
height adjustment)
Figure 5b
2
Fitting the lock pin through
the bracket
=
=
1
4