Usb/Sd/Mmc-Card Playback; Cassette Playback - Hyundai H-1439 Instruction Manual

repeated up to 20 times.
• Before use, be sure to stop the CD by
pressing STOP button.
• Press PROGRAM button. The display will
show "P01" and "PROGRAM". This indicates
that the set is now in memory programming
mode, at the first memory position. (If you use
an MP3 disc, press FOLDER button to select
a folder.)
• Select a desired track by using
SEARCH and SKIP/SEARCH buttons.
• Press PROGRAM button again to confirm.
The unit will advance to next memory position,
the display will show "P02". Repeat two steps
described above to enter additional memories
into the program if necessary.
• After a maximum of 20 songs (or less)
have been selected as described above,
press PLAY/PAUSE button to start playing the
programmed tracks.
• To check the program you stored, after
completing programming press PROGRAM
button in CD stop mode. Then press
repeatedly SKIP/SEARCH button to see
numbers of all programmed tracks.
• The program memory will be cleared when
you press STOP button twice, open the disc
compartment door or turn off the disc player or
power supply.
Good quality sound is guaranteed only
when playing licensed MP3 discs.

USB/SD/MMC-card playback

• This unit is equipped with a USB socket
that can accept and play MP3 files stored on
standard USB flash (compatible with USB
version 2.0) up to 8 Gb.
• This unit is also equipped with an SD/
MMC card socket that can accept and play
MP3 files stored on standard SD cards up to
32 Gb.
• To use USB drives/SD/MMC cards for
MP3 playback, slide the function switch to CD
position. Insert the USB drive or SD/MMC card
into the appropriate socket and repeatedly
press CD/SD/USB button until the display
shows "USB" or "CARD" (depending on which
Instruction manual
one is being used).
• All operations with files contained in USB/
SD/MMC are the same as operations with MP3
discs.
Always switch off the unit or change
mode to another one before removing a
USB flash drive or SD/MMC card, to prevent
damage to your USB device or memory card.
Note: Although this product is fully
SKIP/ compatible with USB 2.0 and SD/MMC card
standard formats, a small percentage of USB
flash drives and SD/MMC cards might not be
readable, due to those device manufacturers
non-compliance with the full (official) USB and
SD cards standards.

Cassette playback

• Slide the function switch to TAPE position.
• Press STOP/EJECT button to open the
cassette compartment.
• Insert a cassette with the tape-side up
into the proper guide-rails on the inside of the
cassette door.
• Gently push the cassette door forward
(inwards) to close it.
• Press PLAY button to start the playing.
• Adjust the level of sound with VOLUME
regulator.
• Press PAUSE button to pause the playing.
• Press STOP/EJECT button to stop the
playing, press the button again to open the
cassette door and you can take out the tape.
• Press STOP/EJECT button followed by the
REWIND or F.FWD button to rewind or forward
the tape at high speed.
• When the tape plays to the end, playing
will be stopped automatically and releases the
PLAY button at the same time.
To avoid damage of tape or mechanism,
press STOP/EJECT button before each new
operation.
5