Troubleshooting - OEM TY-6300SD Operation Manual

Troubleshooting

Problem
Unit will not turn on
(no power)
Unit has power
(but no sound)
Unit blows fuse
Unit has audio
(but no video)
No video display
(when in reverse)
DVD does not start playback
IR remote does not work
Excessive skipping
ERR-DISC appears on display Focus error or disc is in upside down
Region code error appears
on display
Front panel will not open/close Front panel obstructed
Weak station searching
Unit resets itself when engine
is off
Interruption during playback
Incorrect playback message
displayed
iPod source not available
Cannot see video and photo
media on TFT screen
All other errors
46
Cause
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage
Black wire not connected
Fuse blown
Speaker wires not connected
One or more speaker wires touching each other
or touching chassis ground
Yellow or red wire touching chassis ground
Speaker wires touching chassis ground
Incorrect fuse rating
Parking brake safety circuit not connected
Parking brake not applied
Reverse circuit not connected
Vehicle is not in reverse
Physical defect in media
Wrong region
Dead battery
Unit is not mounted correctly
Physical defect in media
Region code error
Auto antenna is not fully extended
Auto antenna not properly connected
Local function is activated
Incorrect connection between ACC and positive
battery wire
Disc is dirty or scratched
File is damaged/bad recording
Message is longer than LCD can display.
Incorrect cable connections
Wrong iPod Video Settings
Solution
Check connections for proper voltage (11~16VDC)
Check connection to ground
Replace fuse
Check connections at speakers
Insulate all bare speaker wires from each other and
chassis ground
Check for pinched wire
Check for pinched wire
Use fuse with correct rating
Check connections at parking brake
Apply parking brake
Check connections at reverse lamp
Select reverse gear
Check media for scratches
Use discs labeled "Region 1" or "All" only.
Replace battery
Check mounting sleeve
Check media for scratches
Press eject or RESET
Use only DVDs labeled "Region 1" or "All" only.
Remove the obstacle and press OPEN again to
resume the monitor open/close sequence.
Connect the auto antenna control cable properly
Connect the auto antenna control cable properly
Turn LOCAL function OFF
Check wiring and correct
Clean disk or replace
Recreate disc with good files
Check connection of the inport adapter to rear of radio
or connection of iPod to inport adapter
Change iPod video settings to TV Out
Check yellow RCA cable from the inport adapter to the
radio
Reset Radio