Initializing Parking Brake - OEM TY-6300SD Operation Manual

Initializing Parking Brake

SAFETY WARNING
• The video display of the in-dash unit will not operate while the vehicle is moving.
• As a safety feature, "ENGAGE PARKING BRAKE" blue screen will show on the display when the
vehicle's parking brake is not engaged. Video display on the front monitor isn't allowed until the
PARKING BRAKE is active, however, DVD and AV1 audio can be heard while the vehicle is in
motion without engaging the parking brake.
• This is a safety feature to prevent driver distraction. It is illegal in most states for the driver to view
video while the vehicle is in motion. Refer to local laws in your area.
IT'S UNLAWFUL TO OPERATE A VEHICLE WHILE VIDEO IS
Front Monitor Video Initialization
Follow this two initialization procedure carefully to allow video playback on TY-6300SD front panel
monitor:
There are usually two situations that start the PARKING BRAKE Sequence.
Initializing Parking Brake Scenario 1
First situation is while driving:
1) Stop vehicle, put in Park, make sure PARKING BRAKE is off / released
2) Depress PARKING BRAKE for 2 to 3 seconds
3) Release PARKING BRAKE for 2 to 3 seconds
4) Depress PARKING BRAKE permanently
Once above procedure 1-4 is completed, approx 3 sec—video will display.
Initializing Parking Brake Scenario 2
Second situation is while already parked and the PARKING BRAKE is already depressed:
1) Keep vehicle in Park, PARKING BRAKE should be off
2) Release PARKING BRAKE for 2 to 3 seconds
Depress PARKING BRAKE for 2 to 3 seconds
3)
4) Release PARKING BRAKE for 2 to 3 seconds
5) Depress PARKING BRAKE permanently
Notes:
• Once 2nd procedure is completed, approx 5 sec—video will display.
• This procedure will have to repeated if the IGN is turned off.
• The transition time must be less than 2 seconds between depressed and released.
20
CAUTION !!!
DISPLAYED IN THE DRIVERS VIEWING AREA.
ENGAGE EMERGENCY BRAKE
TO ENJOY VIDEO