Basic Setup - Fellowes POWERSHRED 99Ms Instructions Manual

Hide thumbs Also See for POWERSHRED 99Ms:
Table of Contents

Advertisement

Available languages

Available languages

A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, credit cards and staples
Will not shred: Adhesive labels, continous form paper, transparencies, newspaper,
cardboard, paper clips, CD/DVDs, laminates, file folders, X-rays or plastic other than noted
above
Paper shred size:
Micro-Cut .......................................................................................................... 2 x 14mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.
BASIC SET UP
CASTER INSTALLATION
1
2
F.
G.
KEY
A. SafeSense
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
2
3
G. Control Panel and LEDs
Technology
®
1. Overheat (red)
2. Bin open (red)
3. Bin full (red)
4. Remove Paper (red)
5. SafeSense
1. OFF
6. Reverse
2. ON
7. ON/OFF (blue)
8. Forward
Maximum:
Sheets per pass ........................................................................................................... 12*
Paper entry width ........................................................................................9 in. (230mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 6.5Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 1000 sheets per day,
50 credit cards.
12 sheets per pass to avoid jams.
Fellowes SafeSense
shredders are designed to be operated in home and office environments ranging
®
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
) to back out object.
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
4
indicator (yellow)
®
5
ENGLISH
Model 99Ms
( )

Advertisement

Table of Contents
loading

Table of Contents