Basic Setup - Fellowes Microshred 16Ms Quick Start Manual

A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, plastic credit cards, staples, small paper clips and junk mail
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper, cardboard,
large paper clips, folders, X-rays, CD/DVD or plastic other than noted above
Paper shred size:
Micro-Cut ...................................................................5/32 in. x 1/2 in. (4 mm x 12 mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (
shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON SHREDDER. Vapors
from propellants and petroleum based lubricants may combust causing serious
injury.
Do not place near or over heat source or water.
BASIC SET UP
CASTER INSTALLATION
1
2
F.
G.
KEY
A. See safety instructions
B. SafeSense
C. Paper entry
D. Pullout bin
E. Casters
F. Disconnect power switch
2 3
G. Control Panel and LEDs
Technology 1. SafeSense
®
2. Remove Paper (red)
3. Overheat (red)
4. Reverse
5. ON/OFF (white)
6. Forward
1. OFF
2. ON
Maximum:
Sheets per pass (16Ms) ................................................................................................ 16*
Sheets per pass (20Ms) ................................................................................................ 20*
Paper entry width .....................................................................................8.7 in. (220mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 4.8Amps (16Ms), 5.5 Amps (20Ms); heavier paper,
humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates:
*1000 sheets per day, 25 credit cards.
Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
) to back out object. voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
4
Model 16Ms/20Ms
indicator (yellow)
®
ENGLISH
( )