Acura 2007 RL Owner's Manual page 266

Main Menu Table of Contents
Compass System (U.S. model without navigation system)
Using the Voice Control System
You should use the voice control
system as much as possible, and
consider manual entry using the
as a ''back-up''
interface dial
method of entry.
Most of the system's functions can
be controlled by voice commands
activated with the button. To
Talk
control your compass system by
voice:
Press and release the
Talk
Wait for the beep.
Give a voice command.
Once the microphone picks up your
command, the system changes the
display in response to the command
and prompts you for the next
command. Using the Talk
answer the prompts as required.
264
If the system does not understand a
command or you wait too long to
give a command, it responds with
''Pardon,'' ''Please repeat,'' or ''Would
you say again.'' If the system cannot
perform a command or the
command is not appropriate for the
screen you are on, it sounds a beep.
Anytime you are not sure of what
voice commands are available on a
screen, you can always say ''Help'' at
any screen. The system can then
button. read the list of commands to you.
button,
When you speak a command, the
system generally either repeats the
command as a confirmation or asks
you for further information. If you do
not wish to hear this feedback, you
can turn it off. See the Voice
Recognition Feedback
Setup.
If you hear a prompt such as ''Please
use the interface dial to...'' or ''Please
choose an area with the interface
dial.'' the system is asking for input
that cannot be done by voice.
setting in