Advertisement
6. GEOMETRY
6.1 VERTICAL CENTER
1) Set the TV to " NORMAL I" mode.
2) Enter the service mode.
3) Locate the cusor at " V.CENTER" then press " VOL +"
or " VOL -" keys to adjust the center line with the
mechanical center marks of the CRT.
6.2 VERTICAL SIZE
* The VERTICAL CENTER adjustment has to be done in advance.
1) Receive the Retma pattern.
2) Set the TV to " NORMAL I" mode.
3) Enter the service mode.
4) Locate the cursor at " V.SIZE" then press " VOL +"
or " VOL -" keys to adjust the upper part of the picture.
6.3 HORIZONTAL CENTER
1) Apply a RETMA PATTERN signal.
2) Set the TV to " NORMAL I" mode.
3) Enter the service mode.
4) Locate the cursor at " H.CENTER" then press " VOL +"
or " VOL -" keys to adjust the picture centering.
if EEPROM(I702) has been changed;
- Option data has to be change and
- all alignment function has to be readjusted
* The initial state of adjustment are as follows;
- V-Center, V-Size, H-Center, R, G, B, AFT = Center (
- AGC =
* Service Remocon
)
Advertisement
