Table of Contents
Advertisement
There is a lot of image lag when playing
video.
Set "HD optimizer" in the Picture menu to "Off". (
Set "Audio Delay". (
84)
The images from this unit do not appear on
the TV.
The picture is distorted during play, or video
will not play correctly.
Check the connection and the TV's input settings.
The unit's "TV System" setting differs from the TV system
used by the disc now playing. While stopped, keep
pressing [STOP ∫] and [< OPEN/CLOSE] on the main
unit for 5 or more seconds. The system switches from
PAL to NTSC or vice versa. (
Picture may not be seen when more than 4 devices are
connected with HDMI cables.
Reduce the number of connected devices.
The picture may be distorted or a black screen may
appear between scenes recorded with different aspect
ratios.
DVD-R DL and +R DL discs have two writable layers on
one side. Video and audio may momentarily cut out when
the unit is switching layers.
Set "Deep Colour Output" (
(
86) to "Off".
3D video is not output correctly.
Check the settings on this unit and the TV. (
When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video is not
output. (
16)
When the amplifier/receiver which is connected between
this unit and a TV is off, 3D video is not output. (
Discs that have recorded titles with Side by side
(2 screen structure) and that can be enjoyed in 3D are
played back in accordance with the settings of the TV.
When "HDMI Audio Output" is set to "Off", 3D video may
not be output correctly. (
TV reception is not displayed.
Broadcast signals are output from this unit's RF OUT
terminal. Select "On" in "RF OUT ( Aerial Signal )".
(
89)
77)
85)
86) or "Contents Type Flag"
43)
16)
86)
Sound
No sound.
Distorted sound.
Check the connections or amplifier's settings. (
Press [AUDIO] to select the audio. (
To output audio from a device connected with an HDMI
cable, set "HDMI Audio Output" to "On". (
Cannot switch audio.
You cannot switch the audio if "Digital Audio Output" is
set to "Bitstream" (
84)
Operation
The remote control doesn't work.
The remote control and main unit are using different
codes. Change the code on the remote control.
Press and hold [OK] and the
indicated number button at the
same time for more than
5 seconds. (
Unit's display
Software (firmware) is updating when "UPD / " is
displaying on the unit's display. Wait until the update is
completed. (
92)
The HOLD function is activated. (
The unit is on but cannot be operated.
Drive has not been selected properly.
Cannot tune channels.
Check the connections.
"Download from TV" function does not work.
You must connect to a VIERA Link (HDAVI Control 3 or
later) compatible TV with a HDMI cable to download
channel presets. (
12)
Startup is slow.
Startup takes time in the following situations:
– A disc is inserted.
– The clock is not set.
– Immediately after a power failure or the AC mains lead
is connected.
– When the unit is connected with an HDMI cable.
– When the BD-J (
115) application is executing.
– When the "Power Save in Standby" is activated. (
12, 16)
25, 42)
86)
89)
18)
89)
97
VQT3C14
Advertisement
Table of Contents
