Oil Recommendations - DeWalt DW650LAG Instruction Manual

CAUTION: RISk fROM NOISE
WhAt cAn hAppEn
• Under some conditions,
applications and duration of
use, noise from this product
may contribute to hearing
loss.
SaVE tHESE InStruCtIonS
aSSEmbly
WARNING: Do not operate this unit until you read and understand
this instruction manual as well as the product instruction manual for
safety, operation and maintenance instructions.
This engine is only for use in D
in unapproved applications, D
e
damage and the warranty is void.
To mount engine correctly, refer to set-up instructions in shop
manual.
CAUTION: The engine IS NOT filled with oil from the factory. Oil
must be added to the engine before operating or damage to engine
may occur.

oil recommendations

SAE 10W-30 is recommended for general use. Refer to the
Viscosity-Ambient Temperature Chart for recommended oil within
your local area's average temperature range.
notE: Synthetic oil is NOT recommended.
hoW to prEVEnt It
• ALWAys wear certified
safety equipment: ANSI S12.6
(S3.19) hearing protection.
WALT approved applications. If used
e
WALT is not responsible for repairs or
VIscosIty-AMbIEnt tEMpErAturE chArt
5W-30
˚F -20 0 20
˚c -28.8 -17.7 -6.6
TO add Oil (Fig. 1)
1. Refer to Viscosity-Ambient Temperature Chart above for correct
viscosity.
2. Remove dipstick.
3. Slowly add recommended oil, see specifications for oil capacity.
notE: If the oil is added too quickly, it will overflow and appear
to be full.
See To Check Oil under Maintenance for instructions.
to ADD FuEL
WARNING: Risk of explosion or fire. Gasoline vapor is highly
flammable. Refuel outdoors only in well-ventilated areas. Do not
refuel or check gasoline level while the engine is running. Do not
store, spill or use gasoline near an open flame,
a source of sparks (such as welding) or near
operating electrical equipment.
1. Remove fuel cap (A).
7
30
10W-30
40 60 80 100
4.4 15.5 26.6 37.7
A
B