Cleaning; Functional Inspection - Husqvarna K 760 Operator's Manual

Cleaning

External cleaning
• Clean the machine daily by rinsing it with clean water after
the work is finished.
Cooling air intake
• Clean the cooling air intake when needed.
NOTICE! A dirty or blocked air intake results in the machine
overheating which causes damage to the piston and
cylinder.
Spark plug
• If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
• Ensure that the spark plug cap and ignition lead are
undamaged to avoid the risk of electric shock.
• If the spark plug is dirty, clean it and at the same time
check that the electrode gap is 0.5 mm. Replace if
necessary.
NOTICE! Always use the recommended spark plug type!
Use of the wrong spark plug can damage the piston/
cylinder.
These factors cause deposits on the spark plug electrodes,
which may result in operating problems and starting
difficulties.
• An incorrect fuel mixture (too much or incorrect type of
oil).
• A dirty air filter.
MAINTENANCE

Functional inspection

General inspection
• Check that nuts and screws are tight.
Blades
Replacing the blades
The blades have integrated belt pulley halves and are to be
changed in pairs.
• Loosen the bar nuts one turn anticlockwise.
• Screw the belt adjuster a few turns anticlockwise.
• This will position the drive belt in a more favourable
position with regard to assembling the new blades. The
drive belt is not clamped so easily.
• Dismantle the old blades by loosening the centre nut.
• Check the drive belt for wear. See instructions under the
heading "Belt drive".
– 17
English