Table of Contents
Advertisement
c. Attach the Lamp door.
2. Replacing the power units.
Remove the 4 screws to take off the ballast bracket.
NOTE : One of screws is behind the Front Shade.
CAUTION
When re-assembling,
tighten this screw at the
torque of 0.49±0.1N·m so
t h a t t h e b o t t o m c a s e
does not strain.
ED-X10/ED-X12(CC9XM2)
Lamp door
Tighten this screw using a manual screwdriver.
Power supply bracket
Remove the
Front Shade
The ballast bracket holding the bal-
last power unit is installed under-
neath the power supply bracket.
Be careful not to injure your fin-
gers or hand by the edges of the
ballast bracket during mainte-
nance around the power units.
44
CAUTION
N O T E : D e t a c h i n g p o w e r
unit(circuit)
PCB holder
Push
Push
UP
CAUTION
PCB holder
UP
keep
Ballast bracket
Hide quick links:
Advertisement
Table of Contents
