Restore Default Settings - ActionTec ScreenBeam Pro SBWD100A EDU User Manual

NVIDIA Shield
To activate ultra-low delay with NVIDIA Shield running:
1. Go to "Settings", then select Miracast.
2. Tap on the toggle switch to turn "Game Mode" on.
Note: The output resolution will be set to 720P once this mode is enabled. Refer to
the device's user manual for more information.

Restore Default Settings

To restore ScreenBeam Pro's default settings:
1. Power on ScreenBeam Pro and wait until the "Ready to Connect"
screen appears.
2. Hold down ScreenBeam Pro's "Reset" button with the end of a paper clip.
3. When the "Reset to Default" screen appears on the HDTV, release the Reset
button.
ScreenBeam Pro reboots. When it finishes, it will running with its default settings.
Display Options
20