Part One - Corsair VENGEANCE K70 RGB Manual

LIGHTING
ASSIGNMENTS

PART ONE

LIGHTING OVERVIEW
(Continued)
Copying and Pasting a Light
If you have two or more markers in the lighting grid,
you may copy the color from one and paste it into
another�
1� In the lighting grid, right-click the source
marker, and then click Copy�
2� Right-click the destination marker, and then
click Paste�
3� The destination marker will change to the
pasted color, but duration and intensity will
remain the same� Adjust the intensity and
color, as needed�
Deleting a Light
In the lighting grid, right-click the marker, and then
click Delete�
Clearing a Light Section
If you have defined multiple markers for the ripple,
and want to delete all the markers prior to or after a
specific marker, you can clear multiple lights at once�
• To clear all the lights to the right of a marker,
right-click the marker, and then click Clear
to right�
• To clear all the lights to the left of a marker,
right-click the marker, and then click Clear
to left�
Cloning a Start or End Light
You can clone the start or end point of a ripple to
the opposite end, to help create continuity in color
and luminance for the start and end of the lighting
effect for use when lighting repeats�
• Right-click the marker you want to clone, and
then click Clone to other end-point�
• In the lighting grid, a marker with the same color
and intensity will appear at the opposite end�
Note: This function is only available with the start
and end lights of a ripple lighting effect�
Adjusting Lighting Brightness
In the Brightness field, click and drag the slider to
the brightness level you want, with 10 being the
brightest, and 0 being the dimmest�
C O R S A I R V E N G E A N C E K 7 0 R G B K E Y B O A R D M A N U A L
75