Specifications - Sony CDX-M730 Operating Instructions Manual

24
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23.2 watts per channel minimum continuous average power into 4 ohms,
4 channels driven from 20 Hz to 20 kHz with no more than 5% total
harmonic distortion.
CD Player section
Signal-to-noise ratio 90 dB
Frequency response 10 - 20,000 Hz
Wow and flutter
Below measurable litnit
Tuner section
FM
Tuning range 87.5 - 107.9 MHz
Antenna terminal External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Usable sensitivity 8 dBf
Selectivity
75 dB at 400 kHz
Signal-to-noise ratio 66 dB (stereo),
72 dB (mono)
Harmonic distortion at I kHz
0.6 % (stereo),
0.3 % (mono)
Separation 35 dB at 1 kHz
Frequency response
30 - 15,000 Hz
AM
Tuning range
530- 1,710kHz
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity 30 pv
Power amplifier section
outputs Speaker outputs
(sure seal connectors)
Speaker impedance 4-Sohms
Maximum power output 52 W x 4 (at 4 ohms)
General
outputs
Inputs
Tone controls
Loudness
Power requirements
Ditnensions
Mounting dimensions
Mass
Supplied accessories
Optional accessories
Optional equiptnent
Audio outputs (front/rear)
Subwoofer output (mono)
Power antenna relay control
terminal
Power amplifier control
terminal
Telephone ATT control
terminal
Illumination control
terminal
BUS control input terminal
BUS audio input terminal
Antenna input terminal
Bass+lOdBat62Hz
Treble &lo dB at 16 kH/
+8 dB at 100 Hz
+2 dB at 10 kHz
I2 V DC car battery
(negative ground)
Approx. 178 x 50 x I82
F?x x 2 x 7'/-1 in.) (w/h/d)
Approx. 182 x 53 x 160
;"?J x 2'/x x 6j/x in.)
(w/h/d)
Approx. I .5 kg (2 lb. IO OZ.)
Parts for installation and
connections (1 set)
Front panel case (1)
Card remote commandet
RM-Xl10
Rotary commander
RM-X6S
BUS cable (supplied with
a" RCA pin cord)
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs)
CDX-656
CD changer (6 discs)
CDX-T69
MD changer (6 discs)
MDX-66XLP
MG-MS System-up Playei
MGS-X I
XM Radio Tuner
XT-XM 1
Source selector
XA-C30
Note
This unit cannot be connected to a digital preamplifier
or an equalizer.
Design and specifications are subject to change
without notice.