Alignment Settings - Panasonic TX-29PN1D Service Manual

ALIGNMENT SETTINGS

(The figures below are nominal and used for representative purposes only.)
1. Set the Bass to maximum position, set the Treble to minimum position, set the Volume to minimum then press the
down button (-/v) on the customer controls at the front of the TV and at the same time press the INDEX button on the
remote control, this will place the TV into the Service Mode 1.
2. Press the RED / GREEN buttons to step up / down through the functions.
3. Press the YELLOW / BLUE buttons to alter the function values.
4. Press the OK button after each adjustment has been made to store the required values.
5. To exit the Service Mode, press the "N" button.
Alignment Function
EAROM copy
FLASH program copy
Horizontal Position
Vertical Position
Horizontal Amplitude
Vert. Amplitude
EW-amplitude
Lower Corner
Trapezium-comp
Upper Corner
Vertical Linearity
Vertical Symmetry
Angle
Bow
DVCO
Highlight
Lowlight
Sub-Brightness
Setting indication
Note: All setting values are approximate
TV/EXT
EXT -> TV
H-Pos
-4
V-Pos
0
H-Amp
93
V-Amp
-15
EW-Amp 1
- 30
Lower Corner
11
Trapez 1
4
Upper Corner
11
V-Lin
39
V-Sym
-6
Angle
0
Bow
0
DVCO
63
High 0374 0318 0335
Low 0207 0331 0256
Sub-Brightness
-10
6
Settings / Special features
---
---
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Receive a PAL Colour Bar Pattern. For
DVCO alignment press "Blue" button, wait
until the figure colour is changed from red
to black colour.
Optimum setting.
Optimum setting.