Table of Contents
Advertisement
7.
Use the
key to highlight 'Clear Message' and press the LSK 'OK'
8.
Press the
key to return to standby.
Registration
You can register up to 6 GAP compatible handsets to each ME4251K base and up to 4 bases
to each handset. Note: Even if a handset other than the ME4251K meets GAP standards, it is
possible that not all the handset functions will be available.
Note: New handsets must be fully charged before you attempt to register them.
To register an additional handset
At the base:
1.
Press and hold the Page key for more than 3 seconds to enter Handset Registration mode.
On the handset:
1.
Press the LSK 'Menu'
2.
Use the
and
keys until 'Settings' is displayed
3.
Press the LSK 'Select'.
4.
Press the
key to highlight 'Handset Setup' and press the LSK 'Select'
5.
Use the
and
keys to highlight 'Registration' and press the LSK 'Select'
6.
Check that 'Register' is highlighted and press the LSK 'Select'
7.
Use the
and
keys to highlight the base that you would like to register the handset to and
press the LSK 'Select'
Note: The base stations that your handset is already registered to will be indicated by '**'.
8.
Using the keypad enter the System PIN code and press the LSK 'OK'.
Note: If you have not changed the PIN code, the default System PIN code is '0000'.
9. If the correct PIN has been entered, the handset displays 'Searching...' whilst it finds and
connects to the base. When registration is complete, the handset will display 'OK' and will be
allocated the next available handset number, which will be shown on the display.
10. Press the
key to return to standby.
07_0022 ME4251UK User Guide1.ind37 37
37
29/1/07 15:46:08
Advertisement
Table of Contents
