Makita LS0714 Instruction Manual page 17

Crown molding stoppers (optional accessories)
allow easier cuts of crown molding without tilting the
saw blade. Install them on the base as shown in the
figures.
1
3
Fig. B
1
3
Fig. B: At right 45° miter angle
Fig. C: At left 45° miter angle
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding stop-
pers as shown in the figure. Adjust the crown mold-
ing stoppers according to the size of the crown
molding. Tighten the screws to secure the crown
molding stoppers. Refer to the table (C) for the
miter angle. Use the sub-fence R to secure the
crown molding more firmly.
2
1 3
Table (C)
Position in
Fig.A
(1)
For inside
corner
(2)
(3)
For outside
corner
(4)
001558
1. Crown molding
2
stopper L
2. Crown molding
stopper R
3. Turn base
001559
1. Crown molding
2
stopper L
2. Crown molding
stopper R
3. Turn base
Fig. C
001560
1. Guide fence
2. Crown molding
4
3. Crown molding
stopper
4. Screw
Miter angle Finished piece
Right 45˚ Save the right side of blade
Save the left side of blade
Left 45˚
Save the right side of blade
Right 45˚
Save the left side of blade
7. Cutting aluminum extrusion
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a cutting
lubricant when cutting the aluminum extrusion to
prevent build-up of the aluminum material on the
blade.
CAUTION:
• Never attempt to cut thick or round aluminum
extrusions. Thick aluminum extrusions may come
loose during operation and round aluminum
extrusions cannot be secured firmly with this tool.
8. Wood facing
Use of wood facing helps to assure splinter-free
cuts in workpieces. Attach a wood facing to the
guide fence using the holes in the guide fence.
See the figure concerning the dimensions for a sug-
gested wood facing.
Over 15mm (5/8")
1
1. Holes
CAUTION:
• Use straight wood of even thickness as the wood
facing.
• Use screws to attach the wood facing to the guide
fence. The screws should be installed so that the
screw heads are below the surface of the wood
facing.
006365
• When the wood facing is attached, do not turn the
turn base with the handle lowered. The blade and/
or the wood facing will be damaged.
17
001844
1. Vise (acces-
sory)
1
2. Spacer block
2
3. Guide fence
4. Aluminum extru-
sion
3
5. Spacer block
4
5
Over 420mm (16-1/2")
27mm (1-1/16")
85mm 70mm 70mm 85mm
(3-3/8") (2-3/4") (2-3/4") (3-3/8")
002206
50mm-60mm
(2"-2-3/8")
1