Traxxas 6708 Stampede 4X4 VXL Owner's Manual page 29

28 STAMPEDE 4x4 VXL
ADVANCED TUNING ADJUSTMENTS
Front Differential Removal
1. 3x15 BCS
6. 3x15 BCS
3.
5.
4. 3x15 BCS
2. 4x10 BCS
6. Remove two 3x15mm button-head screws from diff cover.
Do not remove the two screws that secure the shock tower.
7. Use a 1.5mm hex wrench to remove the two screw pins that
hold the driveshaft yokes to the differential output shafts.
Remove the differential cover and slide the differential out of the
front of the case.
8. To reinstall the differential, reverse the steps.
Rear differential:
1. Remove the two 3x20mm button-head screws that secure the
top bumper mount to diff case.
Rear Differential Removal
6. 3x15 BCS
1. 3x20 BCS
5.
4.
Front of Truck
3. 3x20 BCS
2. Turn the chassis over and remove the two 3x12mm countersunk
crews that hold the bumper/skid plate to the bulkhead. The two
front screws do not need to be removed.
3. Remove the 3x20mm button-head screw from the bumper
mount and tie bar.
4. Slide bumper assembly off of the chassis.
5. Remove the tie bar from the chassis.
6. Remove the two 3x15mm button-head screws from differential
cover. Do not remove the two screws that secure the shock tower.
7. Remove the differential cover and slide the differential out of the
front of the case.
8. To reinstall the differential, reverse the steps.
Refilling the differential:
1. Remove the four 2.5x10mm screws from the differential case
and carefully pull the diff case halves apart. Work over a towel to
collect any luid that drips from the differential.
2. Drain the luid from the differential. You may wish to remove the
spider gears from the differential to make this easier.
3. Place the spider gears back into the diff case, if you removed
them. Fill the diff case with luid until the spider gears are
submerged half way.
4. Rejoin the diff case halves, using care to align the screw holes.
Be sure the rubber gasket is in place, or the differential may leak.
5. Install the 2.5x10mm screws and tighten securely.
2. 3x12 BCS