Advertisement

Quick Links

MODEL 67054
owner
s manual
'

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stampede 4x4 67054 and is the answer not in the manual?

Questions and answers

Summary of Contents for Traxxas Stampede 4x4 67054

  • Page 1 MODEL 67054 owner s manual ’...
  • Page 2 Following the legacy of the Stampede own one of the best-performing models in name, this 4X4 is overbuilt and Traxxas Tough to withstand all the TOOLS, SUPPLIES, AND the market and that it is backed by a team of 4-wheel drive monster mayhem you can dish out.
  • Page 3: Before You Proceed

    SAFETY PRECAUTIONS Traxxas materials to prevent serious damage to your model. Failure to follow All of us at Traxxas want you to safely enjoy your new model. Operate 6200 Traxxas Way these instructions will be considered abuse and/or neglect. your model sensibly and with care, and it will be exciting, safe, and fun McKinney, Texas 75070 for you and those around you.
  • Page 4 LiPo batteries in Traxxas products. your battery packs and your charger. It is your responsibility to charge If you have questions about LiPo battery usage, please consult with and care for your battery packs properly.
  • Page 5: Tools, Supplies, And Required Equipment

    U-joint wrench 8mm/4mm wrench model, but are a good idea to include in any R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers • Phillips screwdriver...
  • Page 6 ANATOMY OF THE STAMPEDE 4X4 Shock Battery Hold-Down Receiver Box Front Body Mount Traxxas High-Current Connector Front Camber Link Rear Camber Link Drive Shaft Battery Shock Guard Rear Shock Tower Front Bumper Spur Gear Front Shock Rear Bumper Tower Front Suspension Arm...
  • Page 7: Getting Started

    GETTING STARTED INSTALLING TRANSMITTER BATTERIES CHARGING THE BATTERY PACK Your TQ 2.4GHz transmitter uses 4 AA batteries. The battery The included charger can be used to charge the included battery If the status LED doesn’t light compartment is located in the base of the transmitter. pack.
  • Page 8 Secure the battery hold-down with a body clip in To run this model, your batteries must be equipped with Traxxas High- the hole in the post. Do not Part #3060 Part #3080 Current Connectors.
  • Page 9 TRAXXAS TQ 2.4GHz RADIO SYSTEM INTRODUCTION NiCad - Abbreviation for nickel-cadmium. The original rechargeable hobby pack, NiCad batteries have very high current handling, high Your model includes the TQ 2.4GHz transmitter. When powered on, the Applying the Decals capacity, and can last up to 1000 charging cycles. Good charging TQ 2.4GHz will automatically locate and lock onto an available frequency,...
  • Page 10 TRAXXAS TQ 2.4GHz RADIO SYSTEM MODEL WIRING DIAGRAM Your model is equipped with the Traxxas TQ 2.4GHz transmitter. XL-5 Wiring Diagram The transmitter has two channels: Channel one operates the Motor steering, and channel two operates the throttle. The receiver...
  • Page 11 TRAXXAS TQ 2.4GHz RADIO SYSTEM RADIO SYSTEM CONTROLS the transmitter. Loss of the radio signal can cause you to lose control of your model. Remember, always turn the • In order for the transmitter and receiver to bind to one another,...
  • Page 12 TRAXXAS TQ 2.4GHz RADIO SYSTEM Throttle reversing procedure: the steering mechanism is not loose or binding. If the steering Note: Throttle reversing is often times unnecessary on electric operates slowly, check for weak batteries. Using Reverse: While driving, models, as issues with the throttle can usually be solved by 6.
  • Page 13 TRAXXAS TQ 2.4GHz RADIO SYSTEM Higher Speeds Require Greater Distance TQ 2.4GHz Binding Instructions The faster you drive your model, the more quickly it will near the For proper operation, the transmitter and receiver must be Failsafe limit of radio range. At top speeds, models can cover anywhere electronically ‘bound.’...
  • Page 14: Adjusting The Electronic Speed Control

    ADJUSTING THE ELECTRONIC SPEED CONTROL XL-5 Battery Settings (Low-Voltage Detection Setting) XL-5 Setup Programming (Calibrating your ESC and transmitter) The XL-5 electronic speed control is equipped with built-in Low- Read through all of the programming steps before you begin. If you XL-5 Specifications Voltage Detection.
  • Page 15 ADJUSTING THE ELECTRONIC SPEED CONTROL XL-5 Profile Selection XL-5 Operation To operate the speed control and test the programming, reconnect The speed control is factory set to Sport Mode (100% forward, Patented Training Mode the motor wires and place the vehicle on a stable block or stand so brakes, and reverse).
  • Page 16 ADJUSTING THE ELECTRONIC SPEED CONTROL Selecting Training Mode LED Codes and Protection Modes (Profile #3: 50% Forward, 100% Brakes, 50% Reverse) • Solid Green: XL-5 power-on light. Low-Voltage Detection is Throttle Neutral Protection 1. Connect a fully charged battery pack to ACTIVATED (LiPo setting).
  • Page 17: Driving Your Model

    • The Traxxas TQ 2.4GHz transmitter is not water resistant. Do not subject it to impossible to give exact run times for the model.
  • Page 18 DRIVING YOUR MODEL After Running Your Vehicle in Wet Conditions • Do not operate your model during a rain storm or other inclement 1. Drain the tires by spinning the tires at high speed to “sling” the weather where lightning may be present. water out.
  • Page 19 DRIVING YOUR MODEL RECEIVER BOX: SETTING UP THE ANTENNA MAINTAINING A WATERTIGHT SEAL The receiver antenna has been set To prevent loss of radio range, Removing and Installing Radio Gear up and installed from the factory. do not kink or cut the black wire, Antenna The unique design of the receiver box allows the removal and The antenna is secured by a 3x4mm...
  • Page 20: Adjusting Your Model

    ADJUSTING YOUR MODEL Shock Mounting Positions Once you become familiar with driving your model, you might need to make adjustments for better driving performance. Big bumps and rough terrain Rear toe-in can be adjusted require a softer suspension Adjusting Gear Mesh using accessory rear axle with the maximum possible Incorrect gear mesh is the most...
  • Page 21 ADJUSTING YOUR MODEL thinner viscosity oils (30W or less) flow more smoothly and are more When going brushless, differential gears, parts #5379 and #6879, Gearing Compatibility Chart: The chart below shows consistent, while thicker oils provide more damping. Use only 100% can be used for maximum durability.
  • Page 22 30,000W viscosity silicone oil. to use a smaller pinion gear to compensate for the larger tire. Soft Only use silicone oil in the differentials. Traxxas offers various compound tires with many short spikes generally work better viscosity oil between SAE 10,000W, and 500,000W (see your parts on hard, dry surfaces.
  • Page 23 ADJUSTING YOUR MODEL 6. Remove the two 3x15mm button-head screws from the Front Differential Removal 3x15 BCS differential cover. Do not remove the two screws that secure the shock tower. 7. Use a 1.5mm hex wrench to remove the two screw pins that hold 3x15 BCS the driveshaft yokes to the differential output shafts.
  • Page 24: Maintaining Your Model

    If the bottom of the shock is leaking, then it condition of the batteries. is time for a rebuild. The Traxxas rebuild kit for two shocks is 8. Check for any loose screws in the chassis structure part #2362.
  • Page 25 MAINTAINING YOUR MODEL Suspension and slipper clutch assembly removal Your model was designed with ease of disassembly in mind. The entire front and rear suspension assemblies can be removed from the chassis fully intact with the removal of only a few screws. Refer to the exploded views included in the your model’s Service Support Guide for complete assembly diagrams.
  • Page 26 ’ 6200 TRAXXAS WAY, MCKINNEY, TEXAS 75070 1-888-TRAXXAS 131216 67054-OM-N-EN-R00...

Table of Contents