Disassembly & Reassembly - Samsung SyncMaster 320TFT Service Manual

5 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
SyncMaster 320TFT/520TFT monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
5-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
5-1-1 Removing the Stand
1. Remove 2 hinge caps on the Rear Cover.
2. Remove 4 screws in the hinge area.
Figure 5-1
3. Push the Stand to the left and remove the
Stand from Body (Front).
4. Remove the Cover Signal.
Figure 5-2
5. Disconnect Power Cord and Signal Cable.
SyncMaster 320TFT/520TFT
5-1-2 Front Cover Disassembly
1. Remove the 4 screws on Rear Cover.
(Point ; )
2. Remove Rear Cover from Front Cover.
3. Remove 6 Main PCB screws on Rear Panel
Bracket. (Point ;
4. Disconnect Main PCB, Inverter wire, Function
wire and Interface wire.
5. Remove Main PCB Assembly.
Figure 5-3
)
5-1