Advertisement
Available languages
Available languages
Installing/Adjusting Leg Extensions /Brake Cables
NOTE: Adjust the product's height so that when the userʹs arm is down to
their side, the hand grip is at wrist height. This will ensure the arms are at an
approximate 20° ‐ 30°
bend when using the product.
1.
Press the snap buttons on each of the front legs and slide the
extension up or down to the desired height.
NOTE: Ensure that the snap button protrudes through the same height
adjustment hole on the each leg extension.
NOTE: An audible "click" will be heard.
2.
Push/pull the brake cables along the side braces so that excess
brake cable is near the rear leg extensions (Rollite models only).
3.
Repeat STEP 1 for the rear leg extensions (Rollite models only).
4.
Coil the excess brake cable by pulling the cable through the cable
tie wraps until the excess cable loops out in front of the side frame
(Rollite models only).
NOTE: For the brakes to function properly, the brake cable MUST be flush
along the leg extension and side brace and the excess brake cable should loop in
front of the side frame.
Adjusting the Hand Brakes (Rollites Only)
Brake Handle
1.
Turn the brake handle adjustment nut
clockwise to loosen.
2.
Turn the brake handle nut counterclockwise
to loosen, or clockwise to tighten.
3.
Turn the brake handle adjustment nut
counterclockwise to secure in place.
4.
Repeat STEPS 1 ‐ 3 for opposite side, if
necessary.
NOTE: If further tension is needed, refer to Cable
Adjuster Unit.
Care and Maintenance
1.
Verify operation of the brakes and adjust them as necessary.
2.
If handgrips are loose, DO NOT use the product. Contact your Invacare dealer.
3.
Inspect wheels periodically for wear and damage.
4.
Replace any broken, damaged or worn items IMMEDIATELY.
5.
Periodically inspect the casters and caster stems for tightness and verify that the wheels are free of hair, lint and other debris that could interfere
with free wheel operation.
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED
AFTER JULY 4, 1975.
This warranty is extended only to the original purchaser/user of our products.
This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state.
Invacare warrants the brakes to be free from defects in materials and workmanship for five years, and all other components for one year for the original
purchaser (excluding tires and wheels). If within such warranty period any such product shall be proven to be defective, such product shall be repaired or replaced, at
Invacare's option. This warranty does not include any labor or shipping charges incurred in replacement part installation or repair of any such product. Invacare's sole
obligation and your exclusive remedy under this warranty shall be limited to such repair and/or replacement.
For warranty service, please contact the dealer from whom you purchased your Invacare product. In the event you do not receive satisfactory warranty service, please
write directly to Invacare at the address on the back page. Provide dealer's name, address, model number, date of purchase, indicate nature of the defect and, if the
product is serialized, indicate the serial number.
Invacare Corporation will issue a return authorization. The defective unit or parts must be returned for warranty inspection using the serial number, when applicable,
as identification within thirty (30) days of return authorization date. DO NOT return products to our factory without our prior consent. C.O.D. shipments will be
refused; please prepay shipping charges.
LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO
THE ENCLOSED INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS IF THE SERIAL
NUMBER HAS BEEN REMOVED OR DEFACED; PRODUCTS SUBJECTED TO NEGLIGENCE, ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR
STORAGE; OR PRODUCTS MODIFIED WITHOUT INVACARE'S EXPRESS WRITTEN CONSENT INCLUDING, BUT NOT LIMITED TO: MODIFICATION
THROUGH THE USE OF UNAUTHORIZED PARTS OR ATTACHMENTS: PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT
WITHOUT THE SPECIFIC CONSENT OF INVACARE; PRODUCTS DAMAGED BY CIRCUMSTANCES BEYOND INVACARE'S CONTROL; PRODUCTS
REPAIRED BY ANYONE OTHER THAN AN INVACARE DEALER, SUCH EVALUATION SHALL BE SOLELY DETERMINED BY INVACARE.
THE FOREGOING EXPRESS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER EXPRESS WARRANTIES WHATSOEVER, WHETHER EXPRESS OR
IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND THE SOLE REMEDY FOR
VIOLATIONS OF ANY WARRANTY WHATSOEVER, SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT PURSUANT TO
THE TERMS CONTAINED HEREIN. THE APPLICATION OF ANY IMPLIED WARRANTY WHATSOEVER SHALL NOT EXTEND BEYOND THE DURATION OF
THE EXPRESS WARRANTY PROVIDED HEREIN. INVACARE SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES
WHATSOEVER.
THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE/PROVINCIAL LAWS AND REQUIREMENTS.
Walklites™ and Rollites™
Brake Handle
Brake
Adjustment Nut
Handle Nut
Brake Cable
Limited Warranty
2
Adjustment
Cable Tie Wrap
Hole
Snap
Button
Brake
Cable
Cable Tie
Brake
Wrap
Cable
Leg
Extension
Adjustment
Cable Adjuster Unit
Screw
1.
2.
Brake
Lever
3.
NOTE: There may be excess brake wire. It may
be necessary to coil the excess wire to keep it
from interfering with brake action. Refer to
Installing/Adjusting Leg Extensions /Brake
Cables.
4.
Jam Nut
Leg
Extensions
Side Frame
Brake
Cable
Side Brace
Loosen the adjustment screw on the
brake clamp.
Adjust the brake wire through the
brake clamp to make it tighter or
looser, as needed.
Tighten the adjustment screw.
Repeat STEPS 1‐3 on the opposite
brake, if necessary.
Part No 1150739
Advertisement
