Insallation; Appropriate Installation Location; Removing The Transportation Safety Assembly; Under Counter Installation - Beko DCU 8230 Installation & Operating Instructions And Drying Guidance

3

Insallation

Before the calling the nearest Authorized Service for the
installation of the dryer, ensure that electrical installation
and water drain is appropriate referring to the user's
manual. (See 3.4 Connecting to the drain and 3.6
Electrical connection) If they are not suitable, contact
a qualified electrician and technician to make necessary
arrangements.
C
Preparation of the dryer's location
as well as the electrical and waste
water installations is under customer's
responsibility.
A
Prior to installation, visually check if the
dryer has any defects on it. If the drier
is damaged, do not have it installed.
Damaged products cause risks for your
safety.

3.1 Appropriate installation location

• Install the dryer on a stable and level surface.
• Dryer is heavy. Do not move it by yourself.
• Operate your dryer in a well ventilated, dust-free
environment.
• The gap between the dryer and the surface should
not be reduced by the materials such as carpet,
wood and tape.
• Do not cover the ventilation grills of the dryer.
• There must not be a lockable, sliding or hinged door
that may block the opening of the loading door in the
place where your dryer is to be installed.
• Once the dryer is installed, it should stay at the same
place where its connections have been made. When
installing the dryer, make sure that its rear wall does
not touch anywhere (tap, socket, etc.).
• Place the dryer at least 1 cm away from the edges
of other furniture.
• Your dryer can be operated at temperatures between
+5°C and +35°C. If the operating conditions fall
outside of this range, operation of the dryer will be
adversely affected and it can get damaged.
B
Do not place the dryer
cable.
Dryer / User Manual
on the power
3.2 Removing the transportation safety
assembly
A
Remove the transportation safety
assembly before using the dryer for the
first time.
• Open the loading door.
• There is a nylon bag inside the drum that contains a
piece of styrofoam. Hold it from its section marked
with XX XX.
• Pull the nylon towards yourself and remove the
transportation safety assembly.
A
Check that no part of the transportation
safety assembly remains inside the drum.

3.3 Under counter installation

This product can be installed under a counter if the
height of the counter is sufficient.
A
While using undercounter dryer, it should
never be operated without undercounter
installation part. For the appropriate
undercounter installation part contact the
Authorized Service.
Leave at least 1 cm of space around the sides and the
rear wall of the dryer when installing it under a counter.
C
If installed under a countertop, drying
durations can extend.
13 / 32 EN