Alesis MULTIMIX 6 CUE Quick Start Manual page 4

Available languages

13. Fuse holder

14. Power Input- Connect the AC power cable to the unit and an AC power socket.

15. Main input connectors- Balanced 1/4" TRS and XLR connectors used to input the stereo signal

16. Main output connectors- Balanced 1/4" TRS and XLR connectors used to output the main

signal. Use these connectors to link several headphone amplifiers together

17. Headphone out 1-6- Sends the same signal as the headphone outputs on the front panel

APPLICATIONS

Headphone Amplifier

1. Send the signal through the Direct input or rear panel Main inputs

2. Ensure the Balanced control is fully counter-clockwise and adjust the input gain control for each of

the headphone outputs being used

3. Use the individual output gain controls to set the desired channel volume

4. Connect the headphone(s) to the headphone output(s)

5. Link as many Multimix 6 Cue mixers together via the Main outs

Independent Power Amplifiers

1. Turn the Balanced controls fully clockwise to the AUX position.

2. The Main input signal will be muted and only signals coming from the Aux inputs are routed to the

headphone outs

3. Up to six independent stereo signals can be sent through the MULTIMIX 6 CUE to provide

individual monitoring for up to six musicians

Studio Application

To mix one source with another, such as an instrumental track with a vocalist, route the instrumental

track through the Direct or Main inputs and route the vocal signal through an Aux input. Adjust the

blend of the signals using the Balanced control and monitor the combined signal through the

headphone outputs.

Mono/Stereo Application

Switch between mono and stereo operational modes via Mode switch. In mono application (Mode

switch pressed down), the two input signals are combined together and the resulting mono signal

routes to the left and right headphone outputs.

Rear Panel