Do you have a question about the Classic 3.0 and is the answer not in the manual?
Questions and answers
Geoff
April 15, 2025
Load disconnects approx 2 minutes in use
1 comments:
Mr. Anderson
April 15, 2025
The load disconnects on the Tunturi Classic 3.0 after approximately 2 minutes of use likely because the meter switches into Sleep mode if you are not training and no buttons are pressed.
With Tunturi Fitness Equipment, • Further information on warranty terms can be found you’ve chosen a high quality, safe and motivating...
Page 3
Fasten the pedal bands to the pedal outside. Push the band through the locking buckle and the band locks automatically. The length of the band can be adjusted with the locking buckle. Bike 3.0 - OWNER’S MANUAL ENGLISH...
POWER CORD 1. Connect the cables from the handlebar to the corresponding connectors of the console. Insert the Plug the socket end of the transformer cord into the connected cables into the console, but make sure they connector, just above the rear support in the centre of the are not damaged when the console is attached.
The transmitter is switched to an active state only when it is being used for measurement. Sweat and other moisture can, however, keep the transmitter in Bike 3.0 - OWNER’S MANUAL ENGLISH...
CONSOLE ADDITIONAL NOTES 1. For speed and distance you can choose either metric or English units by using the KM/ML switch located on the back cover of the meter. The power cord has to be unplugged and replugged to apply the change. 2.
Due to the If you have set target/targets, the target/targets start to measurement system, your Tunturi ergometer need not count down. During training you can scale the load by be re-calibrated when assembled, serviced and used SELECTION DIAL.
Changes or modifications not expressly may strain your back or risk other accidents: approved by Tunturi will void the user’s authority to operate the equipment! NOTE! Always switch the power off and unplug the...
Need help?
Do you have a question about the Classic 3.0 and is the answer not in the manual?
Questions and answers
Load disconnects approx 2 minutes in use
The load disconnects on the Tunturi Classic 3.0 after approximately 2 minutes of use likely because the meter switches into Sleep mode if you are not training and no buttons are pressed.
This answer is automatically generated