Advertisement
1
SPECIFICATIONS
Display : 3½ digit liquid crystal display (LCD) with a maxi-
mum reading of 1999.
Polarlty : Automatic, positive implied, negative polarity in-
dication.
Overrange : (OL) or (-OL) is displayed.
Zero : Automatic.
Low battery indlcation : the "
battery voltage drops below the operating level.
Measurement rate : 2.5 times per second, nominal.
Operating Environment : 0
humidity.
Storage Temperature : -20
0
battery removed from meter.
Accuracy : Stated accuracy at 23
humidity.
Safety : According to EN61010-1 protection class II over-
voltage category (CAT III 600V) pollution degree 2.
Clamp jaw : According ro EN61010-2-032 CAT IV 600V.
Power : single standard 9-volt battery, NEDA 1604, JIS
006P, IEC 6F22.
Battery life : 200 hours typical with carbon-zinc,
Dimensions : 250mm (H) x 100mm (W) x 46mm (D).
Weight : Approx. 380g including battery.
Accessories : One pair test leads, 9V battery (installed).
3
DIGITAL
CLAMP ON
METER
MODEL : 3636
USER MANUAL
" is displayed when the
0
0
C to 40
C at < 70% relative
C to 60
0
C, 0 to 80% R.H. with
0
0
C ± 5
C, <75% relative
®
SAFETY INFORMATION
The following safety information must be observed to insure
maximum personal safety during the operation at this
meter:
1. Do not use the meter if the meter or test leads look
damaged, or if you suspect that the meter is not
operating properly.
2. Use caution when working above 60V dc or 30V ac
rms. Such voltages pose a shock hazard.
3. When Using the probes, keep your fingers behind the
finger guards on the probes.
4. Measuring voltage which exceeds the limits of the
clamp meter may damage the meter and expose the
operator to a shock hazard. Always recognize the meter
voltage limits as stated on the front of the meter.
5. If the equipment is used in a manner not specified
by the manufacturer, the protection provided the
equipment may be impaired.
DC VOLTS
Ranges
Accuracy
Input Impedance
Overload protection : 600VDC or AC rms
AC VOLTS (True RMS) (50Hz - 500Hz)
Ranges
Accuracy
Input Impedance
Overload protectlon : 600VDC or AC rms
RESISTANCE
Rangea
Accuracy
Open circuit volts
Overload protection : 600VDC or AC rms
FREQUENCY (Autoranging)
Ranges
Accuracy
Sensitivity
Overload protection : 600VDC or AC rms
CONTINUITY
Audible lndication
Overload protection : 600VDC or AC rms
: 600V
: ±(0.5% rdg + 1dgt)
: 10MV
: 200V, 600V
: ±(1.2% rdg + 10dgts)
: 10MV
: 2KV, 200KV
: ±(1.2% rdg + 1dgt)
: 0. 3Vdc
: 2KHz, 20KHz
: ±(0.1% rdg + 3dgts)
on all ranges
: 80Vrms min
: less than 30V on 2KV range
2
4
Advertisement
