NAD T 777 Owner's Manual page 11

17 AC MAINS INPUT
The T 777 comes supplied with a separate detachable mains power
cord. Before connecting the plug to the mains powers source,
connect firmly first the other end to T 777's AC Mains input socket.
Always disconnect the mains power plug from the mains power
source first, before disconnecting the cable from the T 777's AC
Mains input socket.
Connect only to the prescribed AC outlet, i.e., 120V 60 Hz (for 120V
version models only) or 230V 50 Hz (for 230V version models only).
18 SWITCHED AC OUTLET
This convenience outlet can supply switched power to another
component or accessory.
The total draw of all devices connected to this outlet must not
exceed 120 watts.
It is powered ON and OFF by the front panel STANDBY button or by
the HTR 8's ON and OFF keys.
19 POWER
Supply the AC mains power to the T 777.
When the POWER switch is set to ON position, the T 777 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or HTR 8 remote
control's [ON] button to switch ON the T 777 from standby mode.
If you intend not to use the T 777 for long periods of time (such as
when on vacation), switch off the POWER switch.
With POWER switched off, neither the front panel Standby button
nor HTR 8 remote control's [ON] button can activate the T 777.
IDENTIFICATION OF CONTROLS
REAR PANEL
11