Needle Up/Down Switch; Sewing Speed Control; Spool Pins - White 979 Instruction Manual

NEEDLE UP/DOWN SWITCH
(Electronic model 979 only)
Your machine is electronically controlled
so
that
the needle
will always
rise to the up' position whenever you stop
sewing.
If you wish to lower the
needle, press the switch
and a
beep
sound will be heard and the needle will move to the down
position. Push it again or activate the foot control and the
needle will move back to the 'up position.
SEWING SPEED CONTROL
(Electronic model 979 only)
The sewing speed is achieved by using the
sewing speed
control in conjunction with
the foot control. The sewing speed
control is moved horizontally to determine the zone of speed
required.
Illustration I Needle upfdown switch
B
Sewing speed control
SPOOL PINS
Place a spool of thread on the spool pin. Secure it with the
spool cap (A) leaving a gap between
the spool
cap
and the
reel of thread to allow the reel to rotate freely.
Pull up the spool pin (B) This is used for bobbin winding
when the machine is already threaded.
INTER RUPTOR AGUJA ARRIBA / ABAJO
(Sélo el modelo 979 electrónico)
Su máquina lleva un control electrónico pars que Ia
rnàquina pare siempre con Ia aguja arriba.
Si desea bajar Ia aguja, pulse el interruptor, sonará un
pitido y bajará Ia aguja a su posición inferior. Vuelva a
pulsar o active el pedal y Ia aguja volverá a subir.
CONTROL DE VELOCIDAD
(5610 el modelo 979 eledtrónico)
La velocidad de costura se regula mediante el control de
velocidad conjuntamente con eI pedal. El control de
velocidad se mueva horizontalmente para determinar Ia
velocidad desesda.
Ilustración I Interruptor aguja arriba/abajo
II
Control velocidad costura
PORTA CARRETES
Coloque un carrete de hilo en el porta.carretes. Fiielo con
Ia tapa (A) asegurándose una salida fluids del hilo.
Tire de Ia barrita (B). Eats se utiliza para el llenado de
canilla cuando Is máquina ya esté enhebrada.
B
PRESSER FOOT LEVER
There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or remove
fabric.
3. Uft it to its highest position to change the presser foot or
to remove thick fabric.
PALANCA PIE PRENSATELAS
Su prensatelas tiene tres posiciones.
1. Bajar el prensatelas para coser.
2. Levantar a palanca a Ia posición media pars nsertar o
mover Ia tela.
3. Levantar a Ia posición mits alta pars cambiar el
prensatelas o pars mover at material grueso.