TP-Link TL-SG108E Installation Manual

Installation Guide

8-Port Gigabit Easy Smart Switch
TL-SG108E
MODEL NO.
2
Installation
The switch can be either located on a desktop or mounted on a wall.
Mounting the Switch on a Desk
1
Step 1.
Place the switch upside down on a at desk
Step 2.
Remove the adhesive backing paper from the rubber
cushions.
Step 3.
Attach the supplied four rubber cushions to the
recessed areas on the bottom at each corner of the
switch.
Step 4.
Turn over the switch.
7106504641 REV1.0.0

Package Contents

Resource CD
TL-SG108E
Installation Guide
8-Port Gigabit Easy Smart Switch
MODEL NO. TL-SG108E
Power Cord and Rubber Cushions IG
1. Make sure that the box contains the above items. If any of
the listed items are damaged or missing, please contact
your distributor.
2. The switch or TL-SG108E mentioned in this User Guide
stands for TL-SG108E 8-Port Gigabit Easy Smart Switch
without any explanation.
2 Mounting the Switch on a Wall
Bottom of the Switch
L=110mm
Step 1.
Drill two holes into the wall. Insert a screw into each hole
and leave a part of its head exposed.
Step 2.
Place the two wall-mounting slots over the screws and
slide the switch down to fasten it.
1

Overview of the Product

The TL-SG108E 8-Port Gigabit Easy Smart Switch is an ideal upgrade from an unmanaged switch, designed for Small and Medium Business networks
that require simple network management. Network administrators can e ectively monitor tra c via Port Mirroring, Loop Prevention and Cable Test
features. To optimize tra c on your business network, it o ers both port and tag based QoS to keep latency-sensitive tra c moving smoothly and
jitter-free. Additionally, port-based, tag-based and MTU VLAN can improve security and meet more network segmentation requirements. Moreover,
with the innovative energy-e cient technology, they are eco-friendly solution for your business network.
Front Panel
1000M LED(Green)
On: Connected to a 1000Mbps device
Flashing: Transimitting/receiving data
10/100M LED(Yellow)
On: Connected to a 10/100Mbps device
Flashing: Transimitting/receiving data
Power LED Reset Button
Ethernet Ports(1-8)
On: Power on
O : Power o
3
Connection
3
Step 1.
Connect equipment
RJ45 TL-SG108E
Cable
Step 2.
Connect power
Rear Panel
Kensington Power Socket
Security Slot
Modem
( TD-8816 for example)
Router
(TL-ER604W for example)
Line
LAN WAN
Cable Cable
Initialization
Powering on the switch, it will automatically initialize and its LED
indicators will respond as follows:
1. The Power LED indicator will light on all the time.
2. After keeping o for several seconds, the rest of the LED
indicators will ash momentarily, and then work normally
after the initialization.
If the LED indicators don't respond as described above,
please check the power supply and its connection.
Internet