Table of Contents
Advertisement
How to use your mē system
1.
Clean the cartridge light output window with a non-
alcohol based wet wipe or soft tissue. This is done in order
to remove hairs and dust from the treatment window.
2.
Connect the power cable into the mē system.
3.
Place the mē system on a table or area near an electrical
wall outlet. Move any other cords away from the mē
system, so they don't get tangled with the cords from the
mē base unit or applicator.
4.
Make sure the applicator is placed in its cradle before
turning on the mē.
5.
Press the power button to turn the system on. Wait until
the indicator next to the power button turns green. Now
the system is ready for use.
6.
Set the desired energy level, Low Medium or High.
7.
The cartridge is pre-loaded with pulses for your use
(100%).
The cartridge indicator shows the percentage of pulses
remaining as you use the system. When the cartridge is
left with 5% only, the Empty indicator starts blinking. When
the indicator shows empty (0%), replace the cartridge.
(see instructions on page 19).
1.
4.
5.
6.
7.
memyelos.com
11
Advertisement
Table of Contents
