Step 5: Connect The Base Unit - Silvercrest Digital Pen User Manual And Service Information

English

Step 5: Connect the base unit

Connect the base unit to the computer to ..
• enter notes in online mode which are then shown directly on the com-
puter screen.
• upload notes onto the computer.
• charge the internal rechargeable battery of the base unit.
Proceed as follows:
1. Connect the USB socket (B) on the base unit to a free USB socket of
your computer with the connection cable.
The following message then appears after a short time: "Found new
hardware ...".
The base unit of the digital pen is detected by your computer. It cannot be
used, however, until the "Note Manager" has been started.
Note: The base unit is supplied with power by an internal rechargeable
battery which is charged through the USB interface. The battery is fully
charged when a battery symbol with three bars is shown on the display
(C).
If the base unit is not recognised, remove and reinsert the USB connector.
You can also try using a different USB socket on your PC.
18
Silvercrest DGP1000