Table of Contents
Advertisement
S
Rear Panel
1
1. 5.1CH ANALOG AUDIO OUT JACKS
- Connect to an amplifier with 5.1ch analog input jacks.
2. DIGITAL AUDIO OUT JACKS
- Use either an optical or coaxial digital cable to connect
to a compatible Dolby Digital receiver.
- Use either an optical or coaxial digital cable to connect
to an A/V Amplifier that contains a Dolby Digital,
MPEG2 or DTS decoder.
3. AUDIO OUT JACKS
Connect to the Audio input jacks of your television or
audio/video receiver.
4. VIDEO OUT JACK
- Use a video cable to connect to the Video input jack on
your television.
- The Video Output in Setup Menu must be set to
Component (I-SCAN) or COMPOSITE/S-VIDEO.
Note
- Consult your TV User's Manual to find out if your TV supports Progressive Scan (P-SCAN).
If Progressive Scan is supported, follow the TV User's Manual regarding Progressive Scan settings in the
TV's menu system.
- If Component (P-SCAN) Video Output is selected in Setup Menu, Video and S-Video Outputs do not work.
- There may be no image output if the DVD player is connected to a TV or display that is not compatible with
the above format.
- See pages 64 ~ 65 to get more information on how to use the setup menu.
E T U P
2
2
3
ENG-9
6
4
5
5. S-VIDEO OUT JACK
- Use the S-Video cable to connect this jack to the
S-Video jack on your television for higher picture
quality.
- The Video Output in Setup Menu must be set to
COMPOSITE/S-VIDEO.
6. COMPONENT VIDEO OUT JACKS
- Use these jacks if you have a TV with Component
Video in jacks. These jacks provide P
- If Component (P-SCAN) Video Output is selected in
Setup Menu, progressive scan mode will work.
- If Component (I-SCAN) Video Output is selected in
Setup Menu, interlaced scan mode will work.
7. SCART JACK
- Connect to a TV scart input jack.
7
, P
and Y video.
R
B
Advertisement
Table of Contents
