Table of Contents
Advertisement
C
O N N E C T I O N S
Connection to a TV (Interlace)
- Connecting to your TV using Component video cables.
- You will enjoy high quality and accurate color reproduction images. Component video separates
the picture element into black and white(Y), blue(P
images. (Audio signals are delivered through the audio output.)
1
Using component video cables (not included), connect the
COMPONENT VIDEO OUT terminals on the rear of the DVD
player to the COMPONENT IN terminals of your TV.
2
Using the audio cables, connect the AUDIO (red and white)
OUT terminals on the rear of the DVD player to the AUDIO (red
and white) IN terminals of your TV.
Turn on the DVD player and TV.
3
Press the input selector on your TV remote control until the
Component signal from the DVD player appears on the TV
screen.
4
Set the Video Output to Component (I-SCAN) in the Display
Setup menu. (See pages 64 to 65)
You can use the VIDEO SEL. button to change the Video
Output mode. (See page 11)
Note
- If Video output is incorrectly set to COMPOSITE/S-VIDEO with the Component cables connected,
the screen will turn red.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 15 to 16)
- The component terminal of your TV may be marked "R-Y, B-Y, Y" or "Cr, Cb, Y" instead of "P
depending on the manufacturer. The number and position of terminals may vary depending on the TV set.
Please refer to the user's manual of your TV.
), red(P
) signals to present clear and clean
B
R
RED
Audio Cable
RED
WHITE
ENG-13
RED
BLUE
GREEN
WHITE
Component cable
(not included)
RED BLUE GREEN
, P
, Y"
R
B
Advertisement
Table of Contents
