Rack Mounting; Mounting In An Eia Standard Rack; Mounting Four Or Fewer Amps In An Open-Backed Rack; Mounting Five Or More Amps, Or When (Even With Four Or Fewer Units) The Back Of The Rack Cannot Be Left Open - Yamaha C450 Owner's Manual

Hide thumbs Also See for C450:
Table of Contents

Advertisement

Rack Mounting

Mounting in an EIA standard rack

If multiple high-power amp units are mounted in a rack with poor ventilation, the heat from the amps will cause the
interior of the amp to become very hot, causing the performance of the amps to be impaired. When mounting amps in
a rack, you must make provision for ventilation so that the heat can escape.
When mounting amps in a rack, please attach ventilation panels above and below the amp to allow air circulation.
When doing so, it is necessary for 35% or more of the entire surface area of a 1U size panel to be open.
Air circulation will be even better if the top surface of the rack has ventilation openings.
Ventilation panel
Yamaha provides an optional 1U-size ventilation panel VP1.
480
Mounting four or fewer amps in
an open-backed rack
Install the ventilation panel above the amps, as shown
in the following figure.
Ventilation panel
(attach to the front
or rear of the rack)
6
Unit: mm
Mounting five or more amps, or
when (even with four or fewer
units) the back of the rack cannot
be left open
Install ventilation panels above and below each amp,
as shown in the following figure.

Advertisement

Table of Contents
loading

This manual is also suitable for:

C320C160

Table of Contents