Getting Ready To Laminate; Loading The Pouch; Easy Set Up; Visual And Audible Ready Alerts - Swingline FUSION 1100L Start Here Manual

English

getting ready to laminate

Easy Set Up

1 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
2 The laminator will respond with a single beep and a sequence of brief flashes across the control
panel.
3 To use the laminator move the slider to the right from the '
depending on which pouch selected. Below the slider you will see a white line, this indicates that
you have switched the laminator on.
Visual & Audible Ready Alerts
4 The laminator will start to warm up - an orange light will be illuminated to the right of the '
When the laminator is ready to use the green light next to the 'tick
series of two beeps are heard.
NOTE: Only use 3 mil/5 mil photo pouches

loading the pouch

1 Take your item to be laminated and place in to the appropriate sized laminating pouch,
ensuring it is firmly located along the sealed edge. This is to help ensure that you get optimal
quality output.
NOTE: Do not cut pouches prior to
lamination.
Before laminating important or unique documents, always run a test pouch through
the laminator using a similar type document.
6
register this product online at www.acco.com
' to the 3 mil or 5 mil position
a
' is illuminated (b) and a
NOTE: Your new laminator may emit a slight
odor during the initial operation. Its is
normal and will diminish after a few
hours of operation.
SEALED EDGE
letter, menu, photo
b
' (a).
SEALED EDGE
Irregular shaped item