Table of Contents
Advertisement
Thunder i7525 (S2676)
Simply plug in the BLUE END of the IDE cable into the motherboard IDE connector, and the other
end(s) into the drive(s). Each standard IDE cable has three connectors, two of which are closer
together. The BLUE connector that is furthest away from the other two is the end that connects to
the motherboard. The other two connectors are used to connect to drives.
TIP: Pin 1 on the IDE cable (usually designated by a colored wire) faces the drive's power
connector.
Serial ATA
Attaching Serial ATA cables to the Serial ATA connectors is illustrated below:
Serial ATA Hard drive
Serial ATA Cable
Serial ATA Connector
Serial ATA Cable
Power Cable
Simply plug in the BLACK END of the Serial ATA cable into the motherboard Serial ATA
connector, and the other end(s) into the drive(s). Each standard Serial ATA cable has two
connectors. Both BLACK ENDS of the Serial ATA cable are the same that are used to connect to
drives or motherboard.
Floppy Drives
22
http://www.tyan.com
Advertisement
Table of Contents
