Sherwood R-945MKII Operating Instructions Manual page 26

Entering video labels
This function can be operated only on video input
sources such as DVD, LDP, VCR 1 and AUX/TV.
Select the desired video input source to
1
enter its label.
INPUT SELECTOR/
INDEX
or
Press the VIDEO LABELS
2
button for more than 2
seconds.
Select the first character of
3
the video label while the
digit is flickering.
Each time the INPUT SELECTOR/INDEX knob is
rotated, the characters changes as follows ;
26 Capital Letters : A B C D E F G H I J K L M N O P
Q R S T U V W X Y Z
10 Arabic Numerals : 1 2 3 4 5 6 7 8 9 0
9 Special Marks :
VIDEO LABELS
INPUT SELECTOR/
INDEX
26
Memorize it within 6 seconds.
4
MEMO / ENTER
If the MEMORY/ENTER button is pressed for more
than 2 seconds on the character, a dot( ) will appear
by the character.
If the MEMORY/ENTER button is pressed without
selecting the desired character, the digit will be blank.
If 6 seconds elapses, repeat again from the step 2.
Repeat steps 3 and 4 to memorize the rest
5
of up to 8 characters.
Note:All 9 characters must be memorized.
Rectifying or clearing a video label
Select the desired video input source to be
1
rectified or cleared.
INPUT SELECTOR/
INDEX
Repeat the steps 2~5 in "Entering video
2
labels" procedure.
To clear a video label, make a blank on each digit,
then the video label is cleared and its factory video
input source will be displayed.
or