Sherwood R-945MKII Operating Instructions Manual page 17

Memorize the desired rear
8
speaker mode while it flickers.
The desired rear speaker mode is memorized and then
it enters the subwoofer mode.
If the rear speaker display disappears, start from the
above step 2 again.
Select the desired subwoofer mode.
9
SPEAKER
MODE
Each time this button is pressed, the subwoofer
mode changes and flickers for 5 seconds as follows;
YES : When using a subwoofer.
NO : When not using a subwoofer.
In case that the front speaker mode is set to
"SMALL", if the subwoofer mode is set to "NO",
then the front speaker mode is automatically set to
"LARGE".
Memorize the desired subwoofer mode
10
while it flickers.
MEMO / ENTER
If the subwoofer display disappears, start from the
above step 2 again.
Checking the speaker setting
MEMO / ENTER
Each time this button is pressed briefly, the
corresponding speaker settings are displayed in turn.
In DTS, Dolby Digital(AC -3), Dolby Pro
Logic or Dolby 3 Stereo mode
11
Test tone will be heard form each speaker for 2
seconds each as follows;
FRONT L
The test tone will be heard from the subwoofer only
when subwoofer is set to "YES" in the DTS mode
and the Dolby Digital(AC-3) mode.
Test tone is not heard from rear speakers in Dolby 3
Stereo mode.
Test tone is not heard from the speaker of which the
setting is adjusted to the NONE or the NO mode.
12
- CENTER LEVEL +
- REAR LEVEL +
The rear L and R volume levels are adjusted
respectively during the test tone function and all
together while enjoying surround sounds.
17
SPEAKER
MODE
Press the TEST TONE
button to adjust the volume
level of each speaker.
CENTER FRONT R REAR R REAR L SUB
Adjust the volume levels of the speakers
until they all sound equally loud.
or