Selecting The Oven Mode - Siemens xTronic HD251U Use And Care Manual

Dual-fuel convection range

page of 110

/ 110
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

Setting the Cooking Mode

1. Touch COOKING MODE.

2. BAKE will flash in the display.

If no further setting is made within 5 seconds,

control will beep and flash. If this occurs, press

START.

3. To change the cooking mode, turn knob.

4. Push START.

The selected mode will appear in the display, along

with the default temperature for that mode, which

will be blinking.

5. To select a different temperature, turn knob to the

right or left (in 5° increments) to desired

temperature.

6. Touch START. If START is not touched, oven will

automatically turn on in 5 seconds.

7. The display alternates between the cooking mode

and preheat.

The preheated temperature is also displayed, starting

at 100ºF. The actual temperature increases until set

temperature is reached, at which point the oven

will beep.

8. To change temperature during cooking, touch

TEMPERATURE. Turn the knob to select new

Temperature and press START.

9. Once cooking has been completed, touch OFF to

turn off oven.

Note: After the oven has been turned off, HOT appears

in the display where the cooking mode was. This is to

indicate that the oven is off but still hot. When the oven

temperature drops below 176° F, HOT is no longer seen

in the display.

Oven Operation Time

The oven will automatically shut off after 12 hours (24

hours if the time format is set for 24 hour in the SELECT

FUNCTION section).

Oven Vent

The oven vent is located below the display above the rear

left cooktop burner.

Caution:

This area may become hot

when the oven is in use

It is normal to see steam escaping from the vent and

condensation may collect on the backguard and cooktop.

This area may become hot when the oven is in use.

Do not block the vent as it is important for air circulation.