Integra DPS-6.5 Instruction Manual page 19

Connecting the DPS-6.5—Continued
• The DPS-6.5 has two S Video output connectors. They
output the same video signal.
• Line up the small triangle above the jack with the same
mark on the plug before plugging in
VIDEO OUTPUT
REMOTE
VIDEO
CONTROL
COMPONENT 2 COMPONENT 1
Y P P Y P P
B R B R
S VIDEO
S VIDEO
S VIDEO IN
Using Component Video
You can use the component video output instead of the
standard video out jack to connect this player to your TV
(or other equipment).
This should give you the best quality picture from the
three types of video output available.
• Use a component video cable (not supplied) to con-
nect the COMPONENT VIDEO OUTPUT jacks to a
component video input on your TV, monitor or AV
receiver.
• If your TV or projector has BNC component video
inputs, use a BNC component video cable to connect
them to the DPS-6.5's BNC component video outputs.
• The DPS-6.5 has two component video outputs. The
COMPONENT 1 output uses RCA connectors. The
COMPONENT 2 output uses BNC connectors. They
output the same video signal.
COMPONENT 1
Y P P
B R
VIDEO OUTPUT
COMPONENT 2 COMPONENT 1
Y P P Y P P
ER AUDIO CD & DVD AUDIO/ B R B
VIDEO PLAYER
DPS- 6.5
ODEL NO.
ATING:
C 120 V 60Hz 11 W
COMPONENT
VIDEO IN
Y P P
B R
IR
IN
AC INLET
RS232
OUT
TV
IR
REMOTE
VIDEO IN
CONTROL
AC INLE
R
RS232
OUT
S VIDEO
TV
Note:
• Watching progressive scan video from the component
video outputs
This player can output progressive scan video from the
component video output. Compared to interlace video,
progressive scan video effectively doubles the scan-
ning rate of the picture, resulting in a very stable,
flicker-free image. To set up the player for use with a
progressive scan TV, see Video Output settings on
page 43. When the player is set to output progressive
scan video, the Progressive indicator lights in the front
panel display.
Important:
• If you connect a TV that is not compatible with a pro-
gressive scan signal and switch the player to progres-
sive, you will not be able to see any picture at all. In
this case, switch everything off and reconnect using
the supplied video cable, then switch back to Interlace
(see page 19).
Switching the video output to interlace
using the front panel controls
Switch the player to standby then, using the front panel
controls, press Standby/On while pressing
the player back to Interlace.
Standby/On
Standby/On
Display
Standby
Dimmer
Compatibility of this player with
progressive-scan and high-definition TVs
This player is compatible with progressive video Macro
Vision System Copy Guard.
Consumers should note that not all high-definition tele-
vision sets are fully compatible with this product and
may cause artifacts to be displayed in the picture. In case
of 525 progressive scan picture problems, it is recom-
mended that the user switch the connection to the "stan-
dard definition" output (Interlace). If there are questions
regarding our TV set compatibility with this model,
please contact our customer service center.
to switch
Open /Close
19