Connecting To A Tv - Integra DPS-5.3 Instruction Manual

Connecting to a TV

Before connecting
• Refer also to the instruction manual of the TV.
• When you connect the DVD Player to the TV, be sure to turn off the
power and unplug both units from the mains before making any
connections.
• Connect the DVD Player to the TV directly. If you connect the DVD
Player to a VCR, TV/VCR combination, or video selector, the playback
picture may be distorted as DVD videos are copy protected.
Making component video connections
If the TV or monitor has component video inputs, making this
type of video connection will produce the ideal picture quality for
the presentation of DVD-Video. Using a component video cable
(sold separately), connect the VIDEO OUTPUT COMPONENT
jacks to the corresponding component video input jacks on the
TV.
Actual labels for component video inputs may vary depending on
the TV manufacturer. (e.g. Y, R-Y, B-Y or Y, C
In some TVs or monitors, the color levels of the playback picture
may be reduced slightly or the tint may change. In such a case,
adjust the TV or monitor for optimum performance.
: Signal flow
IR
OUT
IN
Connecting to a TV Using the Audio/Video
Connection Cable
If the TV or monitor has an S video input, make the S video
connection. The S video connection will provide higher
quality picture playback.
Notes
• If you make the S video connection, leave the yellow plug
disconnected.
• If the TV audio is monaural, leave the red plug disconnected.
IR IN/OUT jacks
The following equipment (sold separately) is essential for
operation:
• Onkyo's Multi-Room System kits (IR Remote Controller Extension
System), or
• Multiroom A/V distribution and control systems from Niles  and
Xantech  to name a few.
• Xantech is a registered trademark of Xantech Corporation.
• Niles is a registered trademark of Niles Audio Corporation.
, C )
B R
Active subwoofer
(for powerful bass
sound)
RS-232
VIDEO ANALOG
OUTPUT OUTPUT
COMPONENT
Y MONO
P
VIDEO B L
P R R
S VIDEO
• Connect the plugs securely.
BE sure to set the TV Aspect after connection using
the Setup Navigator explained in "Setting Up the
Player" starting on page 16 or the function setting
menu explained in "Adjusting Audio and Video
Settings" starting on page 38.
Component video cable
To component video inputs
Stereo audio connection cable
To audio input
DIGITAL
OUTPUT
REMOTE
CONTROL
OPTICAL COAXIAL
L
R
Stereo audio/video connection cable
To audio/video inputs
S video connection cable
To S video input
from connecting block
Mini plug cable
IR
RS-232
OUT
IN
: Signal flow
DPS-5.3
Incomplete
Insert completely
TV
L (White)
R (Red)
AC INLET
DVD PLAYER
DO NOT connect
DPS-5.3
MODEL NO.
the mains lead at
this time.
R (Red)
L (White)
Video
(Yellow)
TV
other component
IR Emitter
Mini plug
Remote
control
sensor
Emitter
Mini plug cable
IR
RS-232
OUT
IN
DPS-5.3
13