Troubleshooting - Insignia User Guide User Manual

Insignia NS-LTDVD19-09 19" LCD TV/DVD Combo
5 Secure the pedestal stand with four M4
screws (2).
6 Reattach the shield panel with the ST3
screws (1) you previously removed.
Cleaning the cabinet
Wipe the front panel and other exterior surfaces
of your TV with a soft cloth lightly dampened with
lukewarm water.Never use a solvent or alcohol
to clean your TV. Do not spray insecticide near
your TV. Such chemicals may cause damage
and discoloration to the exposed surfaces.
Care and handling of discs
Handling discs
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints do not
get on the surface. Never stick paper or tape on
the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of
heat and never leave it in a parked car exposed
to direct sunlight.
2 2
2
2
1
1
www.insignia-products.com
Cleaning discs
Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.
Note
Never operate this product immediately after
moving it from a cold location to a warm location.
Leave it for two or three hours without operating it.
If you use this product in such a situation, it may
damage tapes, discs, or internal parts.

Troubleshooting

TV
Problem Solution
No picture or • Check all cable connections.
sound • Make sure that your TV is turned on.
Picture is OK, but Check the volume level and mute setting.
no sound
Sound is OK, but • Check the color control and adjust it.
no color • Check the program's color features
because it may be a black and white
movie.
The picture has Make sure that the antenna is installed correctly.
overlapped If not, adjust the antenna toward the
images broadcasting station.
Picture has snow • Check the antenna and its connection. If
there are problems, correct them. If all
connections are tight, the problem may
be with a faulty antenna or cable.
• Check car traffic or neon signs that may
disrupt the image.
Stripes on picture Check for interference from other electronic
devices, such as radios and televisions, and
keep magnetic or electronic devices away from
your TV.
Bad stereo or A long broadcast distance, or interference from
SAP sound radio waves, can cause bad sound reception. If
so, change the mode to Mono.
Remote control Remove obstacles between the remote control
does not work and the player. Point the remote control at your
TV's IR sensor. Install fresh batteries.
"Unsupported" Check the resolution and frequency of your
appears on the computer, and adjust it to the optimum
screen resolution for this TV: 1440×900 at 60Hz.
"No Signal" Make sure that the cable is firmly connected to
appears on the the computer and TV.
screen
Image is not clear Adjust the phase control.
Image is not Adjust the horizontal control.
centered
33