Table of Contents
Advertisement
68
1.
Turn off the power of the computer and wait for a while (about 30 seconds).
2.
Insert a pin having length 40 mm or longer and thickness 1 - 1.8 mm (such as a
clip extended straight) into the manual emergency ejecting hole and push it on the
level slowly and intensely.
Then the tray is pushed out.
3.
Hold the tip of the tray to pull it out slowly.
4.
Take off the disk.
To close the tray, check the cause of unallowable disk ejection, turn on the power if no error
is found, and press the eject button. If the disk ejection is still disabled, contact your service
representative.
Data Read/Write
For how to write data into a DVD-RAM disk and how to read data from a disk available for
the Built-in DVD-RAM drive, refer to the manuals of the used operating system and the
relevant application.
Notes on Data Handling ~Security of Important Data~
As well as other recording media, the DVD-RAM disk does not fully secure data integrity. To
avoid problems such as loss or destruction of important data saved in a DVD-RAM disk due
to a defect of the disk or some hardware malfunction, it is recommended to handle such
data in the following ways.
Advertisement
Table of Contents
