Installing Latching Rails on the Built-in DVD-RAM Drive
Install the latching rails on the Built-in DVD-RAM drive to prepare the installation of the
Built-in DVD-RAM drive into the 5.25-inch device bay if necessary.
The latching rails should be suitable to the 5-25-inch device bay in the computer.
Depending on the type of the computer, the Built-in DVD-RAM drive may be fixed to the
frame on the 5.25-inch device bay in the computer. In this case, the latching rails may not
be installed on the Built-in DVD-RAM drive.
Put the Built-in DVD-RAM drive on a rugged and flat table. Then install the latching rails on
the right and left sides of the Built-in DVD-RAM drive by using the screws coming with the
Built-in DVD-RAM drive.
Fix each installed rail so that the tip of the rail is located at the position shown in the
•
figure below.
Front panel on the front face of
the Built-in DVD-RAM drive
Use the screws (4) coming with the Built-in DVD-RAM drive, or M3 screws having
•
screw length of 6 mm.
Align the tip of each rail with this face.
Tip of latching rail
53