AEG SANTO C 7 18 40-4i Operating And Installation Instructions page 25

Place guide (A) on the inside part of
the furniture door, in the upper and
lower positions as shown in the fig-
ure and mark the position of external
holes. Having drilled the holes, fix the
A
guide with the screws supplied.
PR166
Fix cover (C) on guide (A) until it clips
into place.
A
C
PR33
Open the appliance door and the fur-
niture door at 90°. Insert the small
8mm
square (B) into guide (A). Put togeth-
er the appliance door and the furni-
ture door and mark the holes as indi-
cated in the figure. Remove the
squares and drill holes with ø 2 mm
at 8 mm from the outer edge of the
door. Place the small square on the
A
guide again and fix it with the screws
supplied.
B
PR167
25