Table of Contents
Advertisement
Installation
Unpacking
All transit bolts and packing must be removed before using the appli-
ance.
Using a spanner,
unscrew
remove the 2 rear
bottom
screws.
Slide out the 2
plastic pins. Lay
the machine on
its back, taking
care
not
squash the hoses. This can be avoided by
placing one of the corner packing pieces
between the machine and the floor.
Remove the polystyrene block from the bot-
tom of the machine and release the two
plastic bags.
Carefully slide out the left-hand bag removing
it towards the right and then downwards.
Slide out the right-hand bag removing it towards the left and then
upwards.
Set the machine
upright and
remove the
remaining rear
screw. Slide out the
relevant pin.
Plug the open holes
with the plugs which
you will find in the plastic bag containing the instruction booklet.
You are advised to keep all
transit devices so that
they can be refitted if the
machine ever has to be
transported again.
and
P1129
to
P1126
P1128
P0001
1
2
3
P1124
P1127
P0002
49
Hide quick links:
Advertisement
Table of Contents
