Audio Recording; Selecting The Audio Input Signals; Adjusting The Audio Recording Level; Monitoring The Sound During Recording - Panasonic AG-DVC200 Operating Instructions Manual

Audio recording

Selecting the audio input signals

1
Select the desired input signals using the
AUDIO IN switch.
To use the front microphone i Select FRONT (MIC).
To use the rear microphone i Select REAR (MIC).
To use the audio products
<Note>
≥When the front microphone has been selected, select ON as the
<FRONT MIC POWER> setting for the MIC/AUDIO sub-menu
item if the phantom mic (+48 V) needs to be supported. (See
page 35)
≥When the exterior microphone is selected and phantom mic
(+48 V) needs to be supported, set the mic power switch to ON.

Adjusting the audio recording level

When the AUTO SELECT CH1/CH2 selector switch is set to AUTO,
the input levels of the CH1 and CH2 sound are automatically
adjusted.
To adjust the input levels of the CH1 and CH2 sound manually,
proceed as follows:
1
Set the AUTO SELECT CH1/CH2 selector
switch to MAN.
2
While monitoring the audio level meter
inside the viewfinder, adjust the AUDIO
LEVEL CH1 and CH2 controls in such a
way that the maximum input level does not
exceed "- - - - - + - - +."
Monitoring the sound during
recording
The audio input signals can be monitored through the monitor
speaker or earphone. When the PHONES jack is used, no sound
will be heard through the monitor speaker.
The volume of the monitored sound can be adjusted using the
MONITOR control.
<Note>
Howl may be caused if the volume of the audio monitor speaker is
too high. In a this situation, rotate the audio monitor level control to
a lower level which does not give rise to howl.
i Select REAR (LINE).
Monitor
speaker
JOG dial button MONITOR control
EX TAPE NEAR END FLUO.
iREC TCG 12:34:56:00
¢1¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
¢2¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
SPOT QUICK FOCUS
1100 LOW LIGHT
/
=========
48K C H 1
C H 2
CH1
CH2
–32 –28 –24 –20 –16 –12 –8
27
AUDIO LEVEL AUDIO LEVEL
CH1 control CH2 control
AUDIO
SELECT
switch
AUDIO IN
switch
PHONES
jack
Mic power switch
AWB+02
Z78
32K .
ATW
F56
.
0d B
FL1
DJ a n -01-01 23:59:00
¢¢¢ min 1 3 . 4V
–4
The reference value
0dB